medi Manumed active E+motion Mode D'emploi page 6

English
Putting on / Taking off
Please note that initial fitting should be supervised by a qualified healthcare
professional.
• Before you put the bandage on, stick the attached strap to the middle of the
cloth-covered support. The wide end of the strap should be attached to the
cloth-covered support so that the thumb opening in the bandage and the
strap are on the same side (Fig. 1).
• Now pull the bandage over your hand. The "E+Motion" slogan should be on
the back of the hand here (Fig. 2).
• Fasten the strap so that the opening in the strap goes over your outside
wristbone (Fig. 3).
• Then attach it by affixing the narrow end of the strap to the strap (Fig. 4).
• Ensure that the support is positioned correctly when you put the bandage
on. The support should be lined up with the underside of your forearm as
straight as possible.
To take it off, undo the strap. Push the palm of your hand out of the bandage.
Apply pressure to the inside pockets and guides, and pull the bandage off your
hand.
Adjusting the splint
The splint can be individually adjusted at a temperature of around 200 °C.
Care instructions
Velcro fasteners should be closed for washing. We recommend using a laundry
bag. The splint must be removed before washing. Fabric softeners, fats, oils,
lotions, ointments and soap residues can affect the material, hinder the Clima
Comfort effect and cause skin irritations.
• Wash the product by hand, preferably using a medi clean detergent, or in
delicate cycle at 30°C using a mild detergent without fabric conditioners.
• Do not bleach.
• Leave to dry naturally.
• Do not iron.
• Do not dry clean.
    
Note on storage
Must be stored dry and at room temperature. Must be protected from the sun
and moisture.