Go Module - Heating Start Flap; Duo Module - Greater Direct Heat Emission (Optional); Adding More Wood - TONWERK T-SKY eco2 Instructions D'utilisation

6.1. GO MODULE – HEATING START FLAP
GO Module GO Module
closed
6.2. DUO MODULE – GREATER DIRECT HEAT EMISSION (OPTIONAL ONLY T-SKY eco
When you wish greater direct heat
emission during the heating up and
burning down phases, simply open
the convection module all or part of
the way after igniting the charge. To
open, push the lever (A) to the front to
the stop. When you wish to raise the
proportion of radiated heat, close the
Duo Module all or part of the way by
pushing the lever back to its initial po-
sition. When you want to utilise direct
heat emission while you are emptying
6.3 ADDING MORE WOOD
!
You must ensure that a window in the room is open in the event of operation with ambient air.
The T-SKY eco
The individually operable starting aid provides support for the heat-up process in
the event of difficult wind or weather conditions. Open the heating start flap by mo-
ving the control knob backwards as far as it will go. To close, push the control knob
to the front as far as it will go.
open
the storage heating stove, simply leave the convection module open. Bear in mind
that direct heat emission reduces the heat storage capacity and causes your sto-
rage heating stove to cool down faster.
DUO Module
closed
When you want to heat for longer, add two pieces of fi ewood when there is an
adequate basic fi ebed. When building the fi e or adding wood, distribute any re-
maining coals evenly with a poker.
Slowly open the firing chamber door, first a gap, so that the pressure in the firing
chamber is equalised. This helps to prevent ash from flying into the oom.
Distribute the basic fi ebed evenly over the firing chamber base, place one-off
two pieces of fi ewood against the rear wall of the combustion chamber, and
release the firing chamber door. The new fi ewood ignites in a few minutes and
burns from bottom to top.
No fi ewood may be added when the basic fi ebed is higher than the ash shield.
Manual model T-SKY eco
When the wood has burnt up completely and all the flames have disappeared, switch
the combustion air slide to the "Symbol –", which shuts off the air supply.
Automatic model:
When the wood has burnt up completely, the thermostatically-controlled air-inlet fla
closes automatically, which helps ensure lasting emission of the radiant heat.
NOTE!
Opening the firing chamber door always and automatically opens the air supply
fla . This closes again when the fi ewood has burned completely and there are only
embers in the firing chambe .
models all include a manual start-up slide.
2
A A
DUO Module
open
/ T-ART eco
2
A
!
The flow of hot air heats
the convection module.
Please use the glove when
operating the stove.
:
2
)
2