Homelite HBV-30A Manuel D'utilisation page 23

HBV-30A.qxd 2/18/02
GB
F D E I
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICING DEALER.
PROBLEM
Engine will not start.
Engine starts but will not
accelerate.
Engine starts but will only run
at high speed at half choke.
Engine does not reach full
speed and emits excessive
smoke.
Engine starts, runs, and
accelerates, but will not idle.
10:08 AM Page 17
P NL S DK N FIN GR HU
English
TROUBLESHOOTING
POSSIBLE CAUSE
1. No spark.
2. No fuel.
3. Starter rope pulls harder now
than when new.
Carburetor requires adjustment.
Carburetor requires adjustment.
1. Oil / fuel mixture is incorrect.
2. Air filter is dirty.
3. Spark arrestor screen is dirty.
4. Carburetor requires
adjustment.
Idle speed adjustment screw on
carburetor needs adjustment.
CZ RU RO PL SLO HR TR EST LT
SOLUTION
1. Check spark. Remove spark plug. Reattach
the spark plug cap and lay spark plug on
metal cylinder. Pull the starter rope and watch
for spark at spark plug tip. If there is no spark,
repeat test with a new spark plug.
2. Push primer bulb until fuel is visible in the
bulb. If fuel is not apparent, the primary fuel
delivery system is blocked. Contact a
servicing dealer. If primer bulb fills, engine
may be flooded (see next item).
3. Contact a servicing dealer.
Contact a servicing dealer for carburetor
adjustment.
Contact a servicing dealer for carburetor
adjustment.
1. Use fresh fuel and the correct 2-stroke oil mix.
2. Clean air filter, refer to "Replacing and
Cleaning the Air Filter" earlier in this manual.
3. Contact a servicing dealer.
4. Contact a servicing dealer for carburetor
adjustment.
Turn idle speed adjustment screw (17) clockwise
to increase idle speed (Fig. 6).
17
LV SK BG