Operation; Mode Of Operation - Meister MET16-16 Traduction Du Manuel D'utilisation Original

8 – Operation
It is normal for the unit to warm up
during operation, this is not a fault.
The device is triple secured against
accidental triggering:
Switching on
Set the switch (4) to the I setting.
Switching of
Set the device to 0.
Impact force controller
In order to preserve material
when working, the impact force
can be continuously increased or
-
+
arrow:
+ = Increase impact force
– = Reduce impact force
We recommend that you determine
the required impact force based on a
sample workpiece.
Trigger
The trigger (1) releases a single shot
when activated and then deactivates
automatically. For each additional shot,
the trigger must be activated again.
CAUTION! Set back, risk of
injury.
36
MW-5459540-Bedien-1910.indd 36
decreased depending
on the substrate and
type of material. To do
this, rotate the impact
force controller (5) in
the direction of the
Trigger lock
t The trigger protection mechanism (9)
ensures that the stapler can only be
triggered when in contact with the
material. To do this press the trigger
protection mechanism up against the
work piece, use both hands if
necessary.
9 – Mode of operation
Single trigger
Position the trigger protection
mechanism (9). Press the unit up against
the material, briefly press the trigger (1)
and release. Before carrying out any
work, test the materials to be joined
for suitability and performance and
select the appropriate staple size in
accordance with Figure 1a.
Eliminating jams, twisted staples and
nails
Depending on how hard the workpiece
is, individual staples may become
jammed in the device. When this
happens, interrupt the process by
unplugging the tool and remove the
staples from the magazine using a pair
of pliers (7).
Soft materials
Slides, textiles, foam, paper: Stretch
the material as required, and position
it exactly before activating the stapler.
Once you have applied the staples or
nails, they are usually very difficult to
remove.
05.11.19 12:21