Components; Correct Use - Meister MET16-16 Traduction Du Manuel D'utilisation Original

normed test procedure and can be used
in order to compare one electrical tool
with another.
The specified vibration emission value
can also be used for an introductory
evaluation of the influence.
CAUTION! The vibration emission
value may fluctuate from the
specified value during use of the
power tool. These fluctuations will
depend on the way in which the
power tool is used.
Try to keep the vibration loads as low
as possible. Examples of measures
that may be taken to reduce the
vibration load include wearing gloves
when using the tool and limiting the
length of the working period. All
parts of the operating cycle must be
taken into account for this purpose
(for example, also including times in
which the power tool is switched of
and times in which it is switched on,
but is running without load).
CAUTION! A certain amount of
noise is unavoidable when using
this device. Ensure you carry out
noise-intensive work during permitted
times. Maintain the quiet periods and
limit your work to the absolute
minimum.
CAUTION! The efects of noise
may cause damage to the hearing.
Only ever work with suitable ear
defenders. Anybody else in the vicinity
should thus also wear ear defenders.
3 – Components
1 Trigger
2 Handle
3 Connection cable
MW-5459540-Bedien-1910.indd 31
4 On/Off switch
5 Impact force controller
6 Magazine lock mechanism
7 Magazine
8 Staple/nail ejection
9 Trigger protection mechanism
4 – Correct use
This electric tacker is suitable for tacking
wood strips, wire mesh, films, cardboard,
shaped sealing materials, decorative and
covering materials, etc. to wood and
other suitable materials with the specified
staples and tacks. All other applications
are expressly excluded.
This device is not designed to be used
by people (including children) with
limited physical, sensory or mental
capacities or those without experience
and/or knowledge. Children should be
supervised to ensure that they do not
play with the device.
The machine is intended only for use in
the household.
Improper use of the product
All applications carried out with the
device that are not listed in the
„Correct use" chapter will be considered
improper use.
Uses for which the tool is not designed
may cause risks and injury. Do not
use accessories that are not intended
specifically for this electrical tool.
Just because you can affix an accessory
to your electrical tool, there is no
guarantee it is safe to use.
The permitted stroke rate of the tool
insert must be at least as high as the
highest value specified on the electrical
31
05.11.19 12:21