Safety Instructions Relating Specifically To The Equipment - Meister MET16-16 Traduction Du Manuel D'utilisation Original

g If devices are provided for the
connection of dust extraction and
collection facilities, ensure these
are connected and properly used.
Use of these devices can reduce dust
related hazards.
4 Power tool use and care
a Do not force the power tool. Use
the correct power tool for your
application. The correct power tool
will do the job better and safer at the
rate for which it was designed.
b Do not use the power tool if the
switch does not turn it on and
of. Any power tool that cannot
be controlled with the switch is
dangerous and must be repaired.
c Disconnect the plug from the
power source before making any
adjustments, changing accessories,
or storing power tools. Such
preventive safety measures reduce
the risk of starting the power tool
accidentally.
d Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to operate
the power tool. Power tools are
dangerous in the hands of untrained
users.
e Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may afect the
power tool's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
f Keep cutting tools sharp and clean.
34
Properly maintained cutting tools with
MW-5459540-Bedien-1910.indd 34
sharp cutting edges are less likely to
bind and are easier to control.
g Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions and
the work to be performed. Use of
the power tool for operations different
from those intended could result in a
hazardous situation.
5 Service
a Have your power tool serviced
by a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the
power tool is maintained.
b If the mains connection cable of
this device is damaged, it must be
replaced with a special connection
cable that can be obtained from
the manufacturer or their customer
service.
6 – Safety instructions
relating specifically to
the equipment
• Always assume that the tool contains
staples. Careless handling of the
stapler can lead to staples being fired
off unintentionally and causes injuries.
• N ever turn the tool on yourself
or on other people. Unexpected
triggering with discharge the staples
and cause injuries.
• Only activate the tool when it is
pressed up firmly against the item
you are working on. If the tool is not
in contact with the work piece, the
staples may miss their target.
05.11.19 12:21