Graphic Equalizer - HQ Power PROMIX1212E Notice D'emploi

52. ON Switch
This switch turns the corresponding digital effect on or off.
53. MAIN/G1-2 Switch
This switch allows you to send the signal from the digital effect mixing bus either to your main mix or to
your G1-2.
54. CLIP Indicators
Located within the digital effects display, the CLIP LED will light up shortly before excessive signals are
dynamically clipped. If the CLIP LED lights up too often, it may be advisable to turn down one or all FX
controls on the input channels to ensure the signal level is not too high.
55. TO MAIN Control
This control adjusts the level of audio to be sent from the digital effects mixing bus to the main mixing.
56. TO AUX 1-2
These controls alter the level of audio that is sent from the digital effects processor to the corresponding
auxiliary mixing buses.
58. FX SEND MASTER Control
This control adjusts the final level of the FX mixing bus, the audio of which is sent to the FX SEND output.
59. MON SEND Control
This control adjusts the final level of the MON mixing bus, the audio of which is sent to the MON SEND
output.
e. Graphic Equalizer Section

60. GRAPHIC EQUALIZER

This stereo 7-band graphic equalizer allows you to adjust the frequency response of a signal with a
maximum of ± 12dB of signal boost or cut for each of the frequencies.
61. MAIN/AUX 1-2
This switch allows you to add EQ either to your main mix or to your AUX 1-2.
62. AUX 1-2 Switch
This switch alternates the use of the equalizer between the use of the AUX 1 bus and AUX 2 bus signals.
63. EQ IN Switch
In the UP position the EQ section is bypassed and there is no effect on any output.
f. Rear Panel
64. AC POWER IN
Connect the included power supply cord on the rear of the console.
PROMIX1212E_v2
9 HQPOWER