Commissioning; Switching The Device On And Off; Setting The Welding Current - Parkside PFDS 120 A2 Consignes D'utilisation Et De Sécurité / Traduction Du Mode D'emploi D'origine

Assembly / Commissioning
the welding device as straight as possi-
ble (place it on the floor).
Take the wire end out of the edge of the
„
spool (see Fig L).
Trim the wire end with wire scissors or a
„
diagonal cutter in order to remove the da-
maged, bent ends of the wire (see Fig. L).
Note: The wire must be kept under ten-
sion the entire time in order to avoid re-
leasing and rolling out!
Therefore, it is recommended to carry out
the work with an additional person.
Push the flux-cored wire through the wire
„
feed guide 31 (see Fig.. M)
Guide the wire along the feed roll
„
and push it into the hose package holder
32
(see Fig. N).
Swivel the thrust roller unit
„
19
the feed roll (see Fig. O).
Mount the adjustment screw
„
O).
Set the counter pressure with the adjust-
„
ment screw. The welding wire must be
firmly positioned between the thrust roller
and feed roll
19
thout being crushed (see Fig. O).
Switch on the welding device on the
„
main 5 switch.
Press the torch button
„
Now the wire feed system pushes the
„
welding wire through the cable assembly
12
and the torch
As soon as 1 – 2 cm of the wire protru-
„
des from the torch neck
11
torch button again (see Fig. P).
Switch off the welding device on the
„
main switch.
Screw the welding nozzle
„
Make sure that the welding nozzle
matches the diameter of the welding
wire used (see Fig. Q). When using the
delivered welding wire (Ø 0.9 mm), the
welding nozzle 15
mm must be used.
Push the torch nozzle
„
torch neck with a turn to the right
Fig. R).
18 GB/IE/NI/CY/MT
19
28
towards
27
(see Fig.
in the upper guide wi-
11 .
10
.
33
, release the
15
back on.
15
with the labeling 0.9
back on to the
9
(see
33
Always unplug the mains
plug from the power socket prior to each
maintenance task or preparatory work in
order to prevent the risk of an electric shock,
injury or damage.
z Commissioning
z Switching the device on and
off
Switch on the welding device on and off
„
the main switch
to use the welding device for an exten-
ded period, remove the plug from the
power socket. This is the only way to
completely de-energize the device.
z Setting the welding current
The rotary switch for the welding current
setting on the front of the welding device
7
can be used to set the desired welding
currents.
The corresponding settings can be found in
the following table.
Voltage (V) Wire feed
A 2 – 4
B 3 – 5
C 3 – 6
D 4 – 8
E 5 – 9
F 5 – 10
G 5 – 10
The necessary welding current depends on
the welding wire diameter used, the material
thickness and the desired penetration depth.
5 . If you do not intend
Welding
current
25 – 75
55 – 85
60 – 100
65 – 105
75 – 110
80 – 115
85 – 120