Connecting The Touch Display - 3M C3266PW Manuel D'utilisation

8

Connecting the Touch Display

3M™ Multi-Touch Displays C4267PW C4667PW C5567PW C6587PW
Power
Switch
3M™ Multi-Touch Display C3266PW
Note: You are cautioned that any change or modification to the equipment not
expressly approved by the party responsible for compliance could void your
warranty.
To connect the Multi-Touch Chassis Display:
1. Turn off the computer before connecting or disconnecting the touch display.
Remote
AC
Input OSD
USB
Touch
AC
Input
Power
USB
Switch
Touch
2. Select the appropriate video cable: Display Port, HDMI, DVI, or VGA. Connect
one end of the video cable to the video connector on the display. Connect the
other end to the video card in your computer.
3. Connect one end of the USB touch sensor cable to the LCD and the other end to
an available port on your computer. For the C3266PW display you also have the
option to connect the RS-232 Serial communications instead of USB.
Note: Do not connect both USB and Serial cables on the display. Choose one or the
other.
4. Connect the power cable to an appropriate grounded power source.
3M Touch Systems, Inc. Proprietary Information
TM
3M Multi-Touch Chassis Display User Guide
RS-232
OUT IN
Display
Port
Serial
Touch
RS-232
OUT IN
Display
Port
HDMI VGA
Port Port
DVI
Audio
Port
VGA
HDMI
Port
Port
DVI
Port
Audio