Important Notes - 3M C3266PW Manuel D'utilisation

3
Intended Use
The 3M™ Touch Displays are designed for touch input and tested to replace an
existing display. These displays are intended for professional installation and use in
an indoor, business environment. They are not designed or tested for use in
hazardous locations. Use in any other application has not been evaluated by 3M and
may lead to an unsafe condition. Not intended for household or personal use.

Important Notes












In extreme temperature and humidity situations, you may observe
condensation between the sensor and the display. To minimize this condition,
place the unit where it will be used and allow a 24-hour environmental
stabilization period prior to powering on the display. Any noticeable
condensation is temporary and will have no long term effect on the operation
of the display.
You are cautioned that any change or modification to the equipment not
expressly approved by the party responsible for compliance could void your
warranty.
When unplugging the power supply cord, hold the plug, do not pull by the
cord.
Do not connect or disconnect this product during a thunder storm or
lightning.
Remember to take into account that the operating temperature of the
installation may be greater than the room ambient, and consideration should
be given to installing the unit in an environment compatible with the
maximum rated operating temperature. Specifications can be found in the
product data sheet on the 3M Touch Systems website at
http://www.3m.com/touch/.
The 3M Multi-Touch Chassis Display may not function as expected at
altitudes higher than 2000 meters.
3M Touch Systems recommends to vacuum or replace the fan filter at least
every six months or if a noticeable rise in surface temperature occurs.
When installing the unit, ensure that it does not restrict the flow of air to any
other equipment within the installation required for safe operation.
An inherent characteristic of the 3M Projected Capacitive Touch (PCT)
sensor is a fine grid pattern that may be visible under certain lighting
conditions.
Install the display in a well-ventilated area. Always maintain adequate
ventilation to protect the display from overheating and to ensure reliable and
continued operation.
Do not expose this display to direct sunlight or heat. Passive heat may cause
damage to the housing and other parts.
3M Touch Systems, Inc. Proprietary Information
TM
3M Multi-Touch Chassis Display User Guide