Teuco HYDROTOP Manuel De L'utilisateur page 10

EN
SWITCHING ON FROM THE REMOTE CONTROL
To switch on, press the "0/I" button; the welcome
message will appear in the control panel display for
a few seconds.
Thereafter, the display switches to READY;
the system can now be used (see Whirlpool).
To switch off the panel, press the "0/I" a second
time:
• if no whirlpool cycle has been selected, the
system shuts off and the display reverts to
STAND-BY.
• If at least one Whirlpool cycle has been selected,
a message will be displayed prompting
DISINFECTION (see DISINFECTION).
AUTOMATIC SHUTOFF:
If no control panel or remote control button is pressed within 30 minutes following power-up or since
the last function was active (TIMER setting) the system shuts off and the display reverts to STAND-
BY. DISINFECTION of the system is not carried out (see DISINFECTION).
10
WELCoME To
HYDRoToP
36 C 20:30
o
READY
Display in READY
20:30
Display in STAND-BY mode
START
DISINFECTIoN?
Display showing
Disinfection prompt
HYDROTOP - Hydrosilence