VOLTCRAFT 1209050 Notice D'emploi page 52

4. Selecting Charging Program
Press the DEC. or INC. button to select the "LiPo BATT" option in the main menu and press
the ENTER button to confirm.
BATT/PROGRAM
Li Po BATT
It is highly recommended to have the menu structure flowchart (Chapter 10) handy while
learning to operate this charger.
5. Selecting Charging Mode
Press the DEC. or INC. button to select the "LiPo Balance Charge" mode and press the
ENTER button to confirm.
LiPo BALANCE CHG
2.0A 11.1V(3S)
6. Setting Charging Values
Press the ENTER button once, and the current value starts blinking. Press the DEC. or
INC. button to change the value and then press the ENTER button to confirm your setting.
LiPo BALANCE CHG
2.0A 11.1V(3S)
At the same time, the battery cells number starts blinking, press the DEC. or INC. button to
change the value and then press the ENTER button to confirm your setting.
LiPo BALANCE CHG
2.0A 11.1V(3S)
Failure to connect as shown in this diagram
will damage this charger. To avoid short
circuit between the charge lead always
connect the charge cable to the charger
first, then connect the battery. Reverse the
sequence when disconnecting.
52