Amplicomms TV 2500 Mode D'emploi page 30

O
PERATION
Operation
Hearing damage due to high volumes!
This receiver allows you to set higher volumes than conventional head-
phones. This can cause hearing damage in persons with healthy hearing
and especially in children.
• Before putting the receiver on, set the volume on the receiver to a low
value.
• Do not continuously expose yourself to high volumes.
1 Switch on the audio source. The green indicator LED on the transmitter
will glow constantly.
2 Switch the On/Off switch on the headset receiver to ON position,
3 Flex the head set arms outwards until the ear buds can be inserted in the
ear. Please note the ear buds can be angled through a movement up,
down or sideways, so as to enter the ear a little deeper. This will improve
the sound quality and volume. Gently press the ear buds further into the
ear to find a comfortable position for the ear buds and an ideal position for
the sound.
4 Adjust the tone clarity setting if necessary.
Note: When the battery level is low you will hear 3 beeps every minute
in the headset receiver. The headset receiver will be switched off auto-
matically after 5 minutes.
The microphone button
The microphone opening at the side of the receiver pick up the sounds of
your surroundings. When the microphone is switched on, you will hear
your surroundings louder. You can hear for example your door bell, your
telephone or your conversational partner even when you are wearing the
receiver.
Press the button to switch the microphone on. The power on indicator will
turn from green to red and two short beeps are to be heard. Make sure that
26
Helpline UK 0844 800 6503
(See page 32 for costs and hours of operation)