External Microphone - Amplicomms TV 2500 Mode D'emploi

Changing the rubber ear buds
Two pairs of ear buds are delivered with the device (L=large/S=small).
The ear buds "L" (large) are already mounted on the headset.
1 For changing the ear buds pick the mounted ear buds at the end and tear
them off simply.
2 Position the spare ear buds onto the "open ends" and let them snap into
place.

External microphone

If your TV set or HiFi system does not have any audio jack you should use
the external microphone.
1 Connect the analogue audio cable to the microphone.
2 Fasten the microphone holder using the adhesive strip adjacent to the
speaker grill on the TV and then clip the microphone into the holder so
that it locates just above the speaker.
3 Please set a very low volume on the TV / on the HiFi system. The positi-
on of the microphone has a decisive influence on the volume - please
determine the best position by experimentation.
Note: The output will be in mono when using the microphone.
Please make sure that the microphone is not too close to the sender,
otherwise this will result in interference being picked up by the micro-
phone which will be heard as digital noise in the headset.
(See page 32 for costs and hours of operation)
Helpline UK 0844 800 6503
G
ETTING STARTED
23