Serial Numbers; Cleaning And Maintenance - Peg-Perego prima pappa zero-3 Notice D'emploi

INSTRUCTIONS FOR USE
1 FITTING THE FRONT AND REAR WHEELS: fit the
two front wheels to the front of the high chair
(fig_a) and the rear ones, with the brake, to the rear
(fig_b), by pushing in the direction of the arrow.
2 OPENING: Lift the seat (fig_a), press the side
buttons (fig_b) and open the high chair (fig_c).
3 BRAKE: the rear wheels of the high chair are
fitted with brakes. To apply the brakes, lower
the levers on the rear wheels. To release
them, raise the levers. It is recommended
that you apply the brakes before carrying out
any procedures involving the high chair.
4 TRAY: To fit the tray, pull the central lever
underneath it towards you while at the same
time pushing it all the way into the armrests
(fig_a). To extend or remove the tray, pull
the central lever underneath it towards you
(fig_b) and move it outwards (fig_c). To
remove the tray, pull the side levers outwards
and pull the tray towards you. The high chair
has a double tray. The top tray can be easily
washed in a dishwasher. To remove it, detach
it from the lower tray and lift it up (fig. d).
5 ADJUSTING THE HEIGHT: The chair can be set
at 7 different heights. To raise or lower the
chair, press the two side levers (fig_a) and
stop in the required position. The handle
under the netting can also be used to raise
the seat (fig_b). The height can be adjusted
in these ways with the child in the high chair.
RECLINING BACKREST: The seat can be
reclined in 5 positions. To adjust it, raise the
handle behind the backrest (fig. c) and lock
it in the required position. This can also be
done with the child in the high chair.
6 ADJUSTABLE FOOTREST: The footrest can be
set in 3 positions. To raise it, push it upwards.
To lower it, push in the two levers and move
the footrest down (fig_b).
7 FIVE POINT SAFETY HARNESS: to close it, insert
the two waist strap buckles (with attached
shoulder straps) into the crotch strap until they
click into position (fig_a). To release it, press the
two sides of the buckles and at the same time pull
the waist strap outwards (fig_b). To tighten the
waist strap pull from both sides in the direction of
the arrow (fig_c), to loosen do the opposite.
8 The shoulder straps of the harness can be set
at two different heights. Partially remove the
fabric covering (fig_a), release the shoulder
straps from the backrest (fig_b) and pull
them out from the fabric covering. Insert
the ends of the shoulder straps in the other
slots in the fabric covering and the backrest
(fig_c), then put the fabric covering back into
the right position on the backrest.
9 USE WITHOUT THE TRAY: to use the seat at
the table, remove the tray. To clip the tray on
the rear supports of the high chair, align and
engage it with the attachments (fig_b).
1 0 CLOSING AND REOPENING THE TRAY: Pull the
central lever underneath the tray towards you
(fig_a) and extend it as far as the red markers
(fig_b), then swing it upwards to lock it in place
(fig_c). To reopen the tray, press the lever under
the armrest (fig_d), swing it downwards, then
pull the central lever towards you and put the
tray in one of the positions for use.
1 1 FOLDING UP: Press the side buttons (fig_a)
and fold up the high chair (fig_b). Fig_c
shows a folded-up high chair. For greater
stability when folded, ensure the wheels are
rotated outwards (fig_d).
1 2 REMOVABLE COVERS: To remove the covers of
the seat, pull off the upper part of the fabric
covering and pull the harness straps through
the backrest (fig_a) and the fabric covering
(fig_b). Lower the backrest and pull out the
leg divider strap from under the seat (fig_c).
1 3 Unbutton the sack at the sides (fig. a) and
pull up to remove it (fig. b).
ACCESSORIES
1 4 BABY CUSHION: Padded cushion for Peg
Perego high chairs and strollers. Winter
side made with cozy matelassé jersey and
summer side made with 100% cotton.
SERIAL NUMBERS
1 5 Information about the production date of the
Prima Pappa Zero-3 can be found on the seat.
_ Product name, date of manufacture and serial
number.
This information is required for any complaints.
CLEANING AND MAINTENANCE
PRODUCT MAINTENANCE: protect from the
weather: water, rain, or snow; prolonged and
continuous exposure to bright sunlight may
give rise to colour changes of various different
materials; store this product in a dry place.
CLEANING THE CHASSIS: periodically clean all
plastic parts with a damp cloth. Do not use
solvent or similar cleaning products; keep all
metal parts dry to prevent rusting; keep moving
parts clean (adjustment mechanisms, locking
mechanisms, wheels, ...) and free of dust and sand
and, if necessary, lubricate with light machine oil.
CLEANING THE SACK: Wash with a damp cloth
and neutral detergent. Do not wring. Do not use
chlorine bleach. Do not iron. Do not dry clean. Do
not use solvents for stain removal. Do not spin dry.
PEG-PÉREGO S.p.A.
Peg Pérego can make changes at any time to
the models described in this publication for
technical or commercial reasons.
PEG-PÉREGO AFTER-SALES
SERVICE
If any parts of your Peg Pérego product
- 9 -