Powering The Case Fans; Installing The Front I/O Connectors; Frequently Asked Questions - Corsair CARBIDE Série Guide D'installation

CARBIDE SERIES

9. Powering the Case Fans

After locating your 3 or 4
pin fan headers on your
motherboard (see your
motherboard's manual
for fan header locations),
plug in the included fan cable.

10. Installing the Front I/O Connectors

See your motherboard's
manual for front panel header
locations and pin-outs.
USB 3.0
USB 2.0
13
SPEC-M2
®
POWER SW HDD LED POWER LED –
HD AUDIO RESET SW
POWER LED +

Frequently Asked Questions

1. How do I remove the I/O Panel ?
If needed, you can uninstall your I/O panel by removing the front
fascia (step 5) then unscrewing the 2 screws at each side of
panel. (see drawing)
2. Does the polarity matter with the I/O panel's power and
reset header?
No, only the LED headers.
3. Who should I contact if I received my case damaged or one of the
fans is no longer working?
Please go to corsair.force.com and request an RMA
so that we can replace the damaged part(s).
4. Where can I mount a fan?
Fan Mount Locations
Front x2 120mm (1 included)
Top
Rear
Bottom
Side
Mid
To learn more about this case visit the product page at corsair.com
x2 120mm
x1 120mm
x
x
x
14