dirna Bergstrom Bycool COMPACT 3.0 Instructions De Montage page 16

COMPACT 3.0
EN
HOW TO CUT EPDM GASKET TO AVOID
!
WATER FILTRATION INTO THE CABIN
A- Glue gasket, keeping 100 mm of protection
paper at each side.
B- Remove the two pieces of paper.
C- Glue by pressing both ends.
B
Gasket
Remove
OUTSIDE CABIN:
4
Position Compact in sun hatch hole.
Caution! When positioning the unit above
the hatch gap, check that the wastewater
run-offs are not blocked by the EPDM
seal.
Position the foam rubber, ensuring the softest
5
part is placed on the base of the unit.
Caution: Depending on the cabin, it may be
necessary to use the (2) supplied ducts in
order for the distribution panel to be completely
adjusted.
A
Gasket
C
Gasket
Gasket
5
16
100 mm Approx. (protection paper)
Sun hatch
®
15 mm
Gasket
Cabin roof
Gasket
4