Placing A Call With The Bluetooth Hands-Free System; Placing A Call With Speech Recognition - Toyota SWC Mode D'emploi

Placing a call with the Bluetooth
system
To place a call, you must first establish a Bluetooth
(see page 10).
You can place a call with the system in these ways:
• Dial a number from the phone (not recommended).
• Digit dial with speech recognition.
• Use the system's contact list.
• Speak a phone voice tag [phone voice name].
• Use the speed dial
• Use the redial
When connected, all of these calls are hands-free. You can terminate a speech recognition session at
any time by pressing the arrow down button.

Placing a call with speech recognition

You can enter a phone number as 1 or more segments of digits. A segment can include up to
15 digits. An entire number can include no more than 32 digits. You can begin the number set
with the * or # character.
Note: Speak numbers as continuous digits. For example, dictate 555-2211 as "5-5-5-2-2-1-1",
not "5-5-5-twenty-two-eleven".
Placing a call with all digits
Action
1 Press and hold the mode button.
2 When prompted, say "Dial number".
The system responds:
3 Dictate the phone number as a single set of digits (without pauses between digits).
The system recites the digits heard.
4 If the number recited by the system is correct, say "Dial".
The system responds: Dialing.
14 Using your Bluetooth
command.
command.
Number please?
®
hands-free system
®
link between the car and your phone
®
hands-free