Maxi-Cosi Dana Mode D'emploi page 11

WARNING
To avoid serious injury:
• Please refer to the manufacturer's instructions
for the use of your infant car seat.
• ALWAYS install car seat facing to the rear
of the stroller.
• ALWAYS use the restraint system in the car
seat.
17 To Attach Maxi-Cosi Mico
Car Seat
NOTES:
• Push the parking brake down.
• Recline seat.
• If desired, remove stroller seat by following
step 17.
To access car seat adapter slots, detach
center seat fastener by pulling up on fabric
above each seat fastener on each side
(Figure 17).
Align car seat adapters with "ribs" facing
inward as shown. Press adapters into slots
(Figure 17a), then slide down until they
"click" (Figure 17a).
Car seat must face the
handlebar.
Lower car seat onto
adapters until both sides "click" (Figure 17b).
To remove Mico car seat, press both buttons
on car seat (Figure 17c). Lift car seat up.
To remove car seat adapters, push tab
as shown, then slide upward and remove
(Figure 17d).
To Use
9
Infant
®
Mico
17
Mico
17b
17d
17a
17c