Installation Of The Filtering Kit - Pelgrim PRS2 Consignes D'installation

INSTALLATION

Installation of the filtering kit

1. Connect the junction to the flexible pipe (A) using the adhesive tape (C).
2. Fix the air junction to the motor outlet.
3. Fix the supplied external flange to the metal box using the supplied screws.
4. Connect the opposite end of the flexible pipe (A) directly to the metal box (B)
using the adhesive tape (C).
5. Release the external metal grid (K), which is supported by a magnet, and then remove the
internal carbon filters (Z) thanks to the external handle.
6. Position the metal box (Y) at the desired exit point and fix it to the piece of furniture and to
the floor using screws (by hand) so that it cannot move or be moved by touching it.
7. Reinsert the active carbon filters (Z) into the metal box (Y) and finally
the external metal grid (K).
EN 6