AVANIT S2X Mode D'emploi page 61

 Place the receiver, cables and remote control in the original packaging.
 Store the receiver and all accessories at a dry and dust-free location.
 Protect the receiver from frost.
18 Troubleshooting
Indication
No sound or
picture, LED at the
receiver is lit.
No sound or
picture.
The TV set has no
picture.
Picture only black
and white and/or
not properly
synchronized.
The remote control
is not working.
If a malfunction cannot be eliminated by the above measures, please contact
your specialized dealer.
19 Disposal
AVANIT S2X
Possible Cause
Receiver is in Standby mode.
No signal or only a weak
signal.
The system is not connected
properly.
The video format of your
receiver is not set properly.
The batteries are used up.
The remote control is aligned
incorrectly.
Never throw receiver and batteries in the normal domestic
waste.
Remedy
To switch on the receiver, press
the POWER key.
Check the cable connections to
the receiver and from the receiver
to the connected units and fasten
them, if necessary.
Check the connection of the
SCART cable and fasten it if
necessary
Adjust the TV standard of your
receiver to that of the TV set.
Replace the batteries with new
ones.
Direct the remote control at the
front panel of the receiver.
Attention!
Troubleshooting
61