Connection To A Unicable System - AVANIT S2X Mode D'emploi

Connection to a Unicable system
4

Connection to a Unicable system

The Unicable function can be applied only if the structure of
the receiving system or its components have been prepared
correspondingly, i.e. if a functional Unicable system is available.
The digital satellite receiver S2X allows switching the receiving mode to the
Unicable standard instead of the different LNB frequencies. Thus, depending on
the system type it is possible to connect up to eight receivers independently
from each other to just one trunk line.
To achieve this, set a separate ZF channel and the corresponding frequency for
every receiver in the Setup menu.
The assignment of channels and frequencies depends on the manufacturer of
LNB or multiswitch.
The data sheet and technical documentation of your LNB and/or multiswitch
contain an assignment table similar to the one below.
Assignment table ZF channels and frequencies
Receiver ZF channel
Receiver 1
Receiver 2
Receiver 3
Receiver 4
Receiver 5
Receiver 6
Receiver 7
Receiver 8
Enter the frequencies of your receiving system in the last
column of the table so that you can always have an overview of
all relevant data at a glance.
42
Sample frequency [MHz]
1 1284
2 1400
3 1516
4 1632
5 1748
6 1864
7 1980
8 2096
Frequency [MHz]
AVANIT S2X