Setting The Zf Channels And Frequencies - AVANIT S2X Mode D'emploi

4.1

Setting the ZF channels and frequencies

 Switch on receiver.
 Press on the remote control
 Select "Installation" using the
confirm.
 Enter the password (on delivery 0000 is preset).
The Installation menu is displayed.
 Select the menu item "Antenna Setup" and confirm.
 Select the menu item "LNB Freq." and select "Unicable (9750-10600)" there
 Select the menu item "IF Channel" and set a ZF channel there
(start with channel "1"; assign one of the ZF channels in ascending order to
every connected receiver).
 Select the menu item "Center Freq" and set the frequency belonging to the
ZF channel (see assignment table).
 If the set frequency is correct, the level indicators "Signal strength" and
"Signal quality" will indicate the value immediately.
 Press the key
The settings are saved.
You are in the "Installation menu" again
 Press the key twice.
The receiver is in the Normal mode and ready to receive.
AVANIT S2X
Connection to a Unicable system
and keys and press to
43