Start-Up Of The Receiver; Switching On; First Start-Up; Language - AVANIT S2X Mode D'emploi

7

Start-up of the Receiver

7.1

Switching on

 Switch on all connected units.
 Switch on the receiver on the mains switch at the rear panel.
The receiver is now in Standby mode.
 Switch on the receiver on the Power key of the unit or on the remote
control.
7.2

First start-up

When you first install your AVANIT S2X it may take up to a minute
from the first plugging in of the power plug until the first menu
window (language) appears.
If the receiver was already connected to the mains, it takes just a
few seconds from inserting the power plug until you see the first
menu screen.
During the first start-up or after a factory reset, the following menus appear
automatically.
7.2.1

Language

Here you can select the menu language of the OSD (On Screen Display).
7.2.2

Receiver Automatic Programming System (RAPS)

Select here whether you want to use RAPS.
If you want to use RAPS (recommended), wait for the 10-second countdown,
after which the RAPS installation will start automatically.
If you do not want to use RAPS (e.g. because you cannot use the Astra 19.2
East satellite), abort the countdown by pressing the EXIT key.
7.2.3
Whenever you switch on your receiver, RAPS will check whether
there are any new channels on the Astra 19.2° E satellite. This will
only take a few seconds. If it finds new channels, they will be added
automatically to the channel list. If channels are switched off permanently, these
channel numbers will be deleted.
AVANIT S2X

How does RAPS work?

Start-up of the Receiver
49