Remote Control; Inserting Batteries; Replacing The Batteries - AVANIT S2X Mode D'emploi

5.2

Remote control

5.2.1

Inserting batteries

5.2.2

Replacing the batteries

 Replace batteries when the range of the remote control is decreasing or
when the receiver no longer reacts to all commands.
• Required batteries 2 size AAA
• When not used for prolonged periods of time, batteries may
• When replacing batteries, always replace all batteries.
AVANIT S2X
The green LED (light emitting diode) on the receiver front
panel does not light immediately after connecting the
device to the power supply ("power LED"), but only after
the installation of programs is completed (either via RAPS
or via program scan), and a video signal is routed to the TV
set.
If you plug the power cord for the first time, the LED lights
up only after installation. During later operation the
receiver's program list already exists; it takes just a few
seconds from inserting the power plug until you see the
green LED.
leak. Remove batteries from the remote control if it is not
used for long periods of time (> 1.5 years).
Overview of the Unit
45