Yamaha RX-V795 Mode D'emploi page 39

To select the tape deck connected to this
unit's TAPE/MD terminals or the source
connected to this unit's EXTERNAL
DECODER INPUT terminals as the input
source.
Use one of the buttons figured below to make the
corresponding indicator illuminated on the display.
Front panel
TAPE/MD MON
/EXT. DECODER
Press once or more.
or
Remote control
HALL
EXT. DEC.
or
0
"TAPE MONITOR": Lights up for a few seconds just
after you select the tape deck
connected to the TAPE/MD
terminals.
"EXT. DECODER": Lights up when the source
connected to the EXTERNAL
DECODER INPUT terminals is
selected.
Note
The input source selected in this way has priority over any
other input source already selected. To select another input
source, cancel both of the sources connected to the TAPE/MD
and EXTERNAL DECODER INPUT terminals.
To cancel both of the sources connected to the TAPE/MD
and EXTERNAL DECODER INPUT terminals.
Use one of the buttons figured above to make neither "EXT.
DECODER" nor "TAPE/MD MONITOR" are illuminated on the
display.
TAPE/MD
MONITOR
MOVIE
THEATER 2
TAPE/MD
3
TAPE/MD
MONITOR
Notes on input source selection
Note that selecting an input source means that the source
which is connected to the corresponding input terminals on
the rear panel is selected.
* To select the source connected to the VIDEO AUX
terminals on the front panel, select "V-AUX".
If you select a video input source without canceling the
source already selected in the way described on the left,
you will see the picture of the video input source and hear
the sound of the source already selected.
If a different audio source is selected with the input selector
keys on the remote controller while enjoying a video source,
the sound from the newly selected audio source is heard,
but the picture from the video source can still be seen.
When you select an input source, the DSP program (or the
state of no DSP program is used) which was used when the
same input source was last selected will be automatically
recalled.
If a nonstandardized source is played back, or the unit
playing back a source is not operating correctly, "INPUT
DATA ERR" appears on the display.
BASIC OPERATION
35