Yamaha RX-V795 Mode D'emploi page 25

For connecting to the REAR and CENTER SPEAKERS
terminals
Red: positive (+)
Black: negative (–)
IMPEDANCE SELECTOR switch
WARNING
Do not change the IMPEDANCE SELECTOR switch
setting while the power to this unit is on, otherwise this
unit may be damaged.
IF THIS UNIT FAILS TO TURN ON WHEN THE
STANDBY/ON SWITCH IS PRESSED:
The IMPEDANCE SELECTOR switch may not be set to
either end. If so, set the switch to either end when this unit
is in the standby mode.
IMPEDANCE SELECTOR
IMPEDANCE SELECTOR
SET BEFORE POWER ON
REAR
REAR
(SURROUND)
CENTER
MAIN A OR B: 4ΩMIN. /SPEAKER
A B: 8ΩMIN. /SPEAKER
REAR
CENTER
MAIN A OR B: 8ΩMIN. /SPEAKER
A B:I6ΩMIN. /SPEAKER
AC OUTLETS
SWITCHED
I20V 60Hz
I00W MAX. TOTAL
Press the tab.
Insert the bare wire.
[Remove approx. 5mm
(1/4") insulation from
the speaker wires.]
Release the tab and
secure the wire.
: 6ΩMIN. /SPEAKER
: 6ΩMIN. /SPEAKER
: 8ΩMIN. /SPEAKER
: 8ΩMIN. /SPEAKER
(U.S.A. model)
Note on main speaker connections:
One or two speaker systems can be connected to this unit. If
you use only one speaker system, connect it to either the
SPEAKERS A or B terminals.
Note on a subwoofer connection:
You may wish to add a subwoofer to reinforce low frequencies
or to output low bass sound from the subwoofer channel when
reproducing discrete signals.
When using a subwoofer, connect the SUBWOOFER terminal
of this unit to the INPUT terminal of the subwoofer amplifier,
and connect the speaker terminals of the subwoofer amplifier
to the subwoofer.
With some subwoofers, including the Yamaha Active Servo
Processing Subwoofer System, the amplifier and subwoofer
are in the same unit. Such a subwoofer needs only the
connection between the SUBWOOFER terminal of this unit
and the INPUT terminal of the subwoofer.
(Refer to page 22 for details about the SUBWOOFER
terminal.)
Select the position whose requirements your speaker system
meets.
(Upper position)
Rear: The impedance of each speaker must be 6Ω or
higher.
Center: The impedance of the speaker must be 6Ω or higher.
Main: If you use one pair of main speakers, the impedance
of each speaker must be 4Ω or higher.
If you use two pairs of main speakers, the impedance
of each speaker must be 8Ω or higher.
(Lower position)
Rear: The impedance of each speaker must be 8Ω or
higher.
Center: The impedance of the speaker must be 8Ω or higher.
<
Main: Except Canada model
If you use one pair of main speakers, the impedance
of each speaker must be 8Ω or higher.
If you use two pairs of main speakers, the
impedance of each speaker must be 16Ω or higher.
<
For Canada model only
The impedance of each speaker must be 8Ω or
higher.
PREPARATION
>
>
21