Battery Charging - Bosch GSA 10,8 V-LI Professional Notice Originale

20 | English
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 11.08.2010
Assembly

Battery Charging

Use only the battery chargers listed on the
accessories page. Only these battery charg-
ers are matched to the lithium ion battery of
your power tool.
Note: The battery is supplied partially charged.
To ensure full capacity of the battery, complete-
ly charge the battery in the battery charger be-
fore using your power tool for the first time.
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
battery.
The lithium ion battery is protected against
deep discharging by the "Electronic Cell Protec-
tion (ECP)". When the battery is empty, the ma-
chine is switched off by means of a protective
circuit: The inserted tool no longer rotates.
Do not continue to press the
WARNING
On/Off switch after the ma-
chine has been automatically switched off. The
battery can be damaged.
The battery is equipped with a NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C. A
long battery service life is achieved in this man-
ner.
Observe the notes for disposal.
1 619 P09 020 | (11.8.10)
Dr. Eckerhard Strötgen
Head of Product
Certification
Removing the Battery (see figure A)
– To remove the battery 11 press the unlocking
buttons 5 and pull out the battery down-
wards. Do not exert any force.
Battery Charge-control Indication
The three green LEDs of the battery charge-con-
trol indicator 8 indicate the charge condition of
the battery 11.
– Press the On/Off switch 7 halfway or com-
pletely through to indicate the charge condi-
tion.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green
When no LED lights up after pressing the On/Off
switch 7, the battery is defective and must be
replaced.
Replacing/Inserting the Saw Blade
Before any work on the power tool, remove
the battery.
When mounting the saw blade, wear protec-
tive gloves. Danger of injury when touching
the saw blade.
When changing the saw blade, take care
that the saw blade holder is free of material
residue, e. g. wood or metal shavings.
Selecting a Saw Blade
Use only saw blades suitable for the material be-
ing worked.
An overview of recommended saw blades can
be found at the beginning of these instructions.
Use only ½" universal shank saw blades. The
saw blade should not be longer than required
for the intended cut.
Use a thin saw blade for narrow curve cuts.
Capacity
≥2/3
≥1/3
<1/3
Reserve
Bosch Power Tools