Allen-Bradley 931S-P1C2D-DC Notice D'utilisation page 4

3. Configuring the device
3.1 Tools
A screwdriver with a 2.5 mm blade is required to set the device,
and to connect the conductors to the terminals.
2
3.2 Open the device
Remove the connector Press the lock lightly
on both sides of the housing to unlock it (1),
1
1
remove the upper part of the housing and the
electronics (2).
3.3 Settings
Set input and output ranges, minimum input
values and measuring span via the DIP switches
SW1 and SW2 according to the following tables.
The potentiometers Span (gain) and Zero (offset)
SW2
SW1
can be activated by the switch SW1/8, accessible
from the front below the cover (3), to finely
calibrate the gain and offset
3
Zero
Span
4