Allen-Bradley 931S-P1C2D-DC Notice D'utilisation page 3

1. General instructions
WARNING WARNING
• Disconnect power prior to installation
• Installation only by Qualified personnel
• Follow all applicable local and national electrical codes
• Due to potential hazardous voltages in close proximity, use a non-
conductive tool and proper PPE when adjusting the potentiometers
on the front panel.
Please observe that applications with high insulation voltages require
sufficient space or insulation to adjoining devices.
Protective measures must be taken against electrostatic
discharges (ESD) when mounting and setting 931S-P1C2D-DC.
2. Application
RTD 3 Way Active Converters 931S-P1C2D-DC are used for galvanic
isolation and conversion of temperature, resistance and potentiometer
signals. Input and output signals are calibrated switch selectable via
DIP switches. It is not necessary to adjust the pre-settable measurement
ranges. A +/- 12.5 % variation can be achieved in the respective range by
switching in potentiometers for zero and span. The analog signal is linear
to the temperature and to the resistance or to the potentiometer setting.
3