Daily Maintenance; Faults And Possible Causes - Quality Espresso FUTURMAT Mode D'emploi

DAILY MAINTENANCE

Empty and clean the coffee filters.
Clean the steam pipe with a damp cloth and purge it several times.
Allow the hot water to flow and clean the drainage tray of all coffee remains that are deposited on the bottom
to prevent fermentation that could originate unpleasant odours.
The outside of the machine should be cleaned with a cloth or absorbent cloth moistened in clean water.
NEVER use detergents or abrasive products.
The filter holders should be located in the groups to maintain them at a constant temperature
NOTE:

FAULTS AND POSSIBLE CAUSES

FAULTS
Very short infusion period.
Fast dispensing.
Very weak coffee without
foam (observed in all groups)
Machine does not come up to
pressure, or it builds up very
slowly.
Electrical
operation (gas – electricity)
GB
Low coffee yield.
Slow dispensing.
Weak cold coffee.
Low coffee yield.
Fast dispensing, hot weak
coffee.
.
POSSIBLE CAUSES
Coffee ground course.
Old coffee.
Insufficient electrical power.
Gas pressure switch or main
switch malfunction.
only or mixed
No power supply to the heating
circuit.
Low water level in the boiler.
Filters with large holes.
Course grinding.
Filters with large holes.
Course grinding.
When this malfunction is associated
with other failures it may be due to
other causes.
Adjust the grinding and c heck the
operation. If the problem persists,
adjust the lower valve of the coffee
group.
Leaking steam cock.
When the machine is left connected
during
resistance may be exposed and
burn out.
Dirty level glass.
Lower level pipe obstructed.
Coffee grounds in the cup.
Coffee grounds in the cup.
11
OBSERVATIONS
the night the heater