Safety Advice - Quality Espresso FUTURMAT Mode D'emploi

SAFETY ADVICE

If the power supply cable is damaged it must be replaced by a cable or special assembly to be supplied
by the manufacturer, or by the after-sales service, and must be installed by authorised personnel, so as
to avoid any possible risk of danger
Any adjustment in the hydraulic system will have to be done only by authorized personnel.
This device is not suited for use outdoors unless it is protected from weather conditions (rain, wind,
etc.).
This device cannot be exposed to or cleaned with jets of water or steam.
This device must not be touched with wet hands or when not wearing footwear.
This device can only be installed and used by qualified personnel.
This device must operate at ambient temperatures above 1º C and below temperatures withstood by
people.
To prevent the device from freezing if it is stored at temperatures that are equal to or less than 0º C,
drain the water hydraulic circuit before being stored. If the device does freeze, put it in a place with a
temperature exceeding 10º C and wait for it to thaw. Never turn on the machine's heating circuit until it
has thawed.
This device must not be us ed for any purpose other than that for which it has been designed
(dispensing espresso coffee or hot water for infusions and supplying steam to heat non-flammable
liquids).
This device does not exceed 70 dB of acoustic pressure.
This machine has no parts that can be serviced by the user. It should only be manipulated by Official
Service Agents
Before undertaking any maintenance procedures, the equipment should be completely isolated from all
electrical sources, either by turning off the electrical installation at the power point, or disconnecting the
machine's mains connection lead.
Children do not recognize the dangers associated with machinery. They must be maintained at a safe
distance, and prevented from manipulating it.
People with impaired physical, sensorial or mental capacities, and those who lack appropriate
GB
experience, should not use the machine without the supervision of suitably qualified personnel.
All cleaning procedures should be carried out in accordance with the instructions of this manual.
To ensure correct machine performance, only use Original Parts supplied by the Official Service Agent
or by the Manufacturer.
The Manufacturer declines all responsibility if current legislation of any sort is not enforced in the
general area where the machine is installed.
10