1. General Information
The information provided in these installation and operat-
ing instructions exclusively applies to the devices described
herein. This includes receptacle combinations of different
sizes and equipment as well as multiple socket outlets.
The illustrations in this manual may not exactly correspond
(in a visual sense) to the device, depending on which
version it is. If device-specific information is required, refer-
ence to this is made at the relevant passage in the manual.
In addition to these installation and operating instruc-
tions, the scope of delivery may also contain additional
instructions for device components, which are to be strictly
observed.
In addition to the requirements set out in this manual,
national statutory regulations and provisions in the country
of installation must also be complied with (concerning acci-
dent prevention, work protection, environmental protection,
etc.).
1.1
Contact details
MENNEKES
Elektrotechnik GmbH & Co. KG
Specialist factory for plugs and sockets
Aloys-Mennekes-Strasse 1
D-57399 Kirchhundem
Tel.
+49 (0) 2723 / 41-1
Fax
+49 (0) 2723 / 41-2 14
E-mail
info@MENNEKES.de
Internet: www.MENNEKES.de
4
2. For your Safety
2.1
Intended use
The receptacle combination is to be exclusively used as
stationary power distribution equipment for internal and
external areas and is intended for wall-mounting or mount-
ing on a suitable structure.
MENNEKES Elektrotechnik GmbH & Co. KG accepts no
liability for any consequences arising from improper use of
the device.
Please read these installation and operating instructions
thoroughly before using the device, and always comply with
the information provided.
No liability is assumed for damage or defects arising as a
result of non-compliance with the manual.
Keep these installation and operating instructions available
at the device, and pass these on to the new owner or user
should the device change hands.
There are certain tasks associated with the use of the
device (e.g. the installation and commissioning) that
must exclusively be carried out by a qualified electri-
cian.
This is explicitly pointed out at the beginning of each
relevant chapter.
Warning
Risk of injury through failure to comply with infor-
mation given in operating manual
There is a risk of sustaining major injury, if instructions in
the operating manual are not complied with or if work
steps are not exactly executed as specified in the operat-
ing manual.
• Comply with all the information given in the operating
manual.
• Only carry out the work steps described in the operating
manual.