Installation; General Preparation - Dovre Sense 100 Installation Et Mode D'emploi

Door lock
The appliance is supplied with the latch button (4)
installed. The door is opened by pressing in the latch
button. As the latch button becomes warm during use,
a glove has been supplied which you can use to pro-
tect your hand.

Installation

General preparation

Please check the appliance immediately after deliv-
ery for damage caused during transport or any
other damage or defects. The appliance is attached
to the pallet with screws at the bottom.
If you detect damage caused during transport
or any other damage or defects, do not use the
appliance and notify the supplier.
Remove the removable parts (fire-resistant inner
plates, fire grate, top plate, ash pan) from the appli-
ance before you start installing the appliance.
It is easier to move the appliance and to avoid
damage if the removable parts have been
removed.
Note the location of the removable parts, so
that you can re-position the parts in the correct
place later on.
1. Open the door; see the following figure.
Subject to change because of technical improvements
2. Remove the fire-resistant inner plates; see the fol-
1
2
3
09-20021-011
lowing figure.
a. First remove the baffle plate (09).
The baffle plate is attached at the top with a
metal clip. This is to avoid damage during
transit.
b. Remove the inner plates (10), (11), (07) and
(08) at the side and at the back.
c. Remove the fire basket at the side (02) and
(03) and at the front (04), (05) and (06).
d. Remove the grate and the ash pan (01) and
(12).
Vermiculite inner plates are light and tend
to be ochrous in colour on delivery. They
insulate the combustion chamber to boost
combustion.
09-20021-012
9