Aqua Medic aquafit 1 Mode D'emploi page 7

aquafit 3:
To attach the holding wires to the lamp housing, the light fixings (Fig. 3, No. 10) are screwed into the nuts with
M3 Ø threads on top of the housing using the screws (Fig. 3, No. 13). The locking screw (Fig. 3, No. 8) can be
tightened with the supplied Allen key after the desired angle has been set.
The stainless steel wire is fed through the lamp fixing (Fig. 1 – 3, No. 5) from the top, via non-return cap (6).
It is drawn through the side opening and the light is adjusted to the correct height from the aquarium (min.
distance 30 cm above water level).
Release the fixing:
To remove the light or re-adjust the height, the non-return mechanism is released by pushing down the non-
return cap (Fig. 1 – 3, No. 6) of the light fixing. Note: Hold the lamp tightly. The stainless steel wire can now
be removed from the lamp fixing.
When the light is mounted in the correct position, any surplus wire may be cut off with pliers. To secure it
additionally, the wire is tied up to form a loop (Fig. 4).
Fig. 4: Safety knot
Warranty conditions
AB Aqua Medic GmbH grants the first-time user a 24-month guarantee from the date of purchase on all material
and manufacturing defects of the device. Incidentally, the consumer has legal rights; these are not limited by
this warranty. This warranty does not cover user serviceable parts, due to normal wear & tear ie: impellers or
drive wheels etc. The original invoice or receipt is required as proof of purchase. During the warranty period,
we will repair the product for free by installing new or renewed parts. This warranty only covers material and
processing faults that occur when used as intended. It does not apply to damage caused by transport, improper
handling, incorrect installation, negligence, interference or repairs made by unauthorized persons. In case of
a fault with the unit during or after the warranty period, please contact your dealer. All further steps
are clarified between the dealer and AB Aqua Medic. All complaints and returns that are not sent to
us via specialist dealers cannot be processed. AB Aqua Medic is not liable for consequential damages
resulting from the use of any of our products.
AB Aqua Medic GmbH - Gewerbepark 24 - 49143 Bissendorf/Germany
- Technical changes reserved – 07/2019
7