Aqua Medic aquafit 1 Mode D'emploi page 6

aquafit 3:
Fig. 3: aquafit 3
1. Ceiling suspension
2. Retaining bush for ceiling suspension
3. Ferrule
4. Stainless steel wire
5. Lamp fixing
6. Non-return cap
7. End of wire
Mounting:
The ceiling suspension (1) must be securely screwed to the ceiling. Suitable screws and pegs are provided but
you should ensure your ceiling is capable of holding the weight of the light in this way. Depending on your
ceiling, it may be necessary to use special cavity plasterboard fixings or to screw through into blocks you have
fitted behind the ceiling.
The stainless steel wire (4) is now fed through the retaining bush (2) of the ceiling suspension (1) so that the
ferrule (3) is retained inside the ceiling suspension. The retaining bush is screwed onto the ceiling plate allowing
the stainless steel wire to hang free.
Lamp fixing:
aquafit 1:
The two lamp fixings are screwed into the threads above the housing now. Note: Make sure that the plastic
washer (Fig. 1, No. 8) is placed inbetween.
aquafit 2:
The holding wires at both ends of the lamp have to be screwed into the provided threaded sleeves (Fig. 2, No.
10) by using the fixing screws. The locking screw (Fig. 2, No. 8) can be tightened with the supplied Allen key
(Fig. 2, No. 9) after the desired angle has been set.
6
8. Locking screw
9. Nut for light fixing
10. Light fixing
11. Peg
12. Screw for peg
13. Screw for light fixing