Preparing The Measurement - Sanitas SBM 22 Mode D'emploi

4. Preparing the measurement

Inserting the batteries
• Open the battery compartment lid.
• Insert four 1.5V AA (alkaline type LR6) batteries. Make
sure that the batteries are inserted the correct way round.
Do not use rechargeable batteries.
• Close the battery compartment lid again carefully.
• All display elements are briefly displayed, 24 h flashes
in the display. Now set the date and time as described
below.
If the low battery indicator
you can no longer perform any measurements and must re-
place the batteries. Once the batteries have been removed
from the device, the time must be set again.
Used batteries should not be disposed of in normal
household waste. Dispose of them via your electronics re-
tailer or your local recycling point. You are legally obligated
to do so.
Note: The codes below are printed on batteries containing
harmful substances: Pb: battery contains lead, Cd: battery
contains cadmium, Hg: battery contains mercury.
Setting the hour format, date and time
It is essential to set the date and time. Otherwise, you will
not be able to save your measured values correctly with a
date and time and access them again later.
is permanently displayed,
To set the date and time, proceed as follows:
• Insert the batteries, or press and
hold the setting button SET for at
least 5 seconds if the batteries have
already been inserted.
• Select 12h or 24h mode using the
function buttons -/+. Press SET to
confirm. The year display will start to
flash. Set the year with the function
buttons -/+ and confirm with SET.
• Set the month, day, hour and minute
and confirm each with the setting
button SET.
• The blood pressure monitor switches itself off automatically.
Setting the alarm
You can set 2 different alarm times to remind yourself to
take the measurement. To set the alarm, proceed as follows:
• Press and hold the function buttons - and + simultaneously
for 5 seconds.
• Alarm 1 is shown in the display, "on" or "off" flashes
at the same time. With the function buttons -/+, choose
whether alarm 1
deactivated ("off" flashes) and confirm with the setting but-
ton SET.
• If alarm 1 is deactivated ("off") you automatically switch
to setting alarm 2
20
should be activated ("on" flashes) or
.