Sanitas SBM 22 Mode D'emploi page 17

Masquer les pouces Voir aussi pour SBM 22:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 27
• Do not use the blood pressure monitor on newborns or
patients with pre-eclampsia. We recommend consulting
a doctor before using the blood pressure monitor during
pregnancy.
• Cardiovascular diseases may lead to incorrect measure-
ments or have a detrimental effect on measurement accu-
racy. The same also applies to very low blood pressure,
diabetes, circulatory disorders and arrhythmias as well as
chills or shaking.
• The blood pressure monitor must not be used in connec-
tion with a high-frequency surgical unit.
• Only use the device on people who have the specified
upper arm measurement for the device.
• Please note that when inflating, the functions of the limb
in question may be impaired.
• During the blood pressure measurement, the blood circu-
lation must not be stopped for an unnecessarily long time.
If the device malfunctions remove the cuff from the arm.
• Avoid any mechanical restriction, compression or bending
of the cuff line.
• Do not allow sustained pressure in the cuff or frequent
measurements. The resulting restriction of the blood flow
may cause injury.
• Make sure that the cuff is not placed on an arm in which
the arteries or veins are undergoing medical treatment,
e.g. intravascular access or intravascular or therapy, or an
arteriovenous (AV) shunt.
• Do not use the cuff on people who have undergone a
mastectomy.
• Do not place the cuff over wounds as this may cause fur-
ther injury.
• The blood pressure monitor can only be operated with
batteries.
• To conserve the batteries, the blood pressure monitor
switches off automatically if you do not press any buttons
for 30 seconds.
• The device is only intended for the purpose described in
these instructions for use. The manufacturer is not liable
for damage resulting from improper or careless use.
Instructions for storage and maintenance
• The blood pressure monitor is made from precision and
electronic components. The accuracy of the measured
values and service life of the device depend on its careful
handling:
– Protect the device from impacts, humidity, dirt, marked
temperature fluctuations and direct sunlight.
– Do not drop the device.
– Do not use the device in the vicinity of strong electro-
magnetic fields and keep it away from radio systems or
mobile telephones.
17

Publicité

Table des Matières
loading

Table des Matières