Télécharger Imprimer la page

Bpt NEHOS NH-BC Mode D'emploi page 6

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
7
16
15
14
Description of rear panel (fig. 2)
1
Connector for video entry control system X1 or X2.
2
Access cover to jumper SW1 for programming of video entry
control system address.
3
Portals USB 2.0 (connection of modem, bus interface).
4
Audio connection for voice modem.
5
Video inputs for CCTV.
6
Mains power input.
7
Connector RJ45 for Ethernet LAN 10/100.
8
Portals USB 2.0 for general use.
9
Serial interface portal RS232 for video matrix.
10 Set-up for satellite or digital terrestrial video card.
11 Analogical land socket for TV aerial.
12 Video output (not used).
13 Video output connector PAL SPDIF (not used).
14 VGA video portal for monitor (not used).
15 Connector PS2 for keyboard (not used).
16 Connector PS2 for mouse (not used).
17 FireWire portals (not used).
18 Parallel interface portal for printer (not used).
19 Audio input (not used).
20 Audio output (not used).
21 Microphone input (not used).
Programming video entry control system address
Remove the cover to access the jumper SW1 (fig. 3).
ATTENTION Before proceeding with programming, ensure that
entry panel X2 or the power supplier XA/300LR are set up for
receiver programming.
The extensions can be associated, through programming, to a
maximum of three separate calls from the entry panel.
1 - Remove jumper SW1 (fig. 3).
An acoustic signal repeated every 5 s on the entry panel confirms
programming status.
2 - Make the call (maximum three separate calls) which from the
panel should activate the receiver .
An acoustic signal on the panel confirms that programming of
each call has occurred.
3 - Refit jumper SW1 to exit programming.
4 - Exit programming of video entry control system in the panel
X2 or in the power supplier XA/300LR.
6
17
8
18
1
2
3
12
13
4
9 19 20 21
10
11
5
6
SW1
NOTE. It is possible to program the receiver through MPP/300LR
or the programming software PCS/300 using the dedicated profile
for the receiver XC/310.
2
3

Publicité

loading