Parts List - Cembre RH-TFC Notice D'utilisation Et Entretien

3.3) Replacement of the automatic coupler
To replace the automatic coupler proceed as follows:
– Remove the old coupler
– Carefully clean the thread of the head to remove the old sealant.
– Apply teflon tape to the thread.
– Fit the new automatic coupler and tighten to 30 Nm (22 lbf ft).
3.4) Blade changing
The blade may become worn or damaged through prolonged or improper use.
Replace the damaged blade as follow:
– Remove the die set from the head, operate the pump to advance the blade (10) until the spring
pin (09) in the ram (21) is accessible.
– Use a suitable drift to remove the spring pin (09) and release the blade (10).
– Note the orientation of the blade (10). Remove the blade and fit the replacement.
Fit the spring pin (09) and release the oil pressure.

4. PARTS LIST

(Ref. to Fig. 8)
Code N° Item
6340614 01 M6 DOWEL
6560563 02 LOCKING PIN
6060120 03 Q14-MS COUPLER
6120011 04 CYLINDER
6360300  05 O-RING
6232038 06 TG 0352 LABEL
6650118 07 ø 2,5x3,5 RIVET
6232274 08 TG 0474 METAL LABEL
6760236 09 ø 4x18 SPRING PIN
6420021 10 BLADE
6780157 11 HEAD SUPPORT
6080118 12 ROLLER PIN
The items marked () are those Cembre recommend replacing if the tool is disassembled.
The guarantee is void if parts used are not Cembre original spares.
When ordering spare parts always specify the following:
- code number of item
- name of item
- type of tool
- tool serial number
5
(Ref. to Fig. 7)
DESCRIPTION Qty Code N° Item
6371017 13 ADJUSTMENT RING
1
1 6700064 14 CIRCLIP
1 6900013 15 M3x4 SCREW INOX
1 6760160 16 ø 3x28 SPRING PIN
6440195 17 LOCKING HANDLE
1
1 6040490 18 RAM GUIDING RING
2 6340018 19 M4x6 GRUB SCREW
6520350 20 RETURN SPRING
1
1 6620263 21 RAM
6040220  22 BACK-UP RING
1
1 6230010 23 ECCENTRIC PIN
6800186 24 PROTECTION CAP
2
ENGLISH
DESCRIPTION Qty
1
1
1
1
1
1
1
1
1
1
1
1