Beurer BM 85 Mode D'emploi page 30

You can cancel the measurement at any time by
pressing the START/STOP button
As soon as a pulse is found, the pulse symbol
played.
• Systolic pressure, diastolic pressure and
pulse readings are displayed. The resting
indicator display (see section 6) illuminates
in accordance with the positive or negative
classification.
• appears if the measurement could not
be performed properly (see section 10 "Er-
ror messages/troubleshooting"). Repeat
the measurement.
• Now select the desired user memory by pressing the
M1 or M2 memory buttons. If you do not select a user
memory, the measurement is stored in the most recently
used user memory. The relevant
on the display.
• Press the START/STOP button
blood pressure monitor. The measurement is then stored
in the selected user memory.
.
is dis-
or symbol appears
to switch off the
30
If Bluetooth data transfer has been activated, data
®
is transferred to the "beurer HealthManager"-App after
confirming the user memory (see chapter 8 "Transferring
measured values"). The blood pressure monitor shows the
Bluetooth symbol during data transfer. Press the START/
®
STOP button again to switch off the blood pressure
monitor.
Please note that you must add the blood pres-
sure monitor in "My devices" in the "beurer
HealthManager"-App to enable data transfers. The
"beurer HealthManager"-App must be active to allow
data transfers.
If the current data is not displayed on your smart-
phone, repeat the transfer as described in Chapter 8.
If you forget to turn off the blood pressure monitor, it will
switch off automatically after approximately 3 minutes. In
this case too, the value is stored in the selected or most
recent user memory and the data is transferred if Blue­
tooth ® data transfer has been activated. The Bluetooth
symbol appears on the blood pressure monitor display
during data transfer.
• Wait at least 5 minutes before taking an-
other measurement!
®