Dispensing Hot Water; Preparing Milk Froth And Warm Milk - Bosch Espresso TES 506 Série Notice D'utilisation

en
4. Select the required drink by turning the
upper rotary knob (15) (only one cup
possible).
5. Press the start button (10).
The coffee is brewed and then dispensed
into the cup.
N.B.: Repeat the procedure for another
cup of coffee. If no coffee is taken within
90 seconds, the brewing chamber empties
automatically to avoid overi lling. The appli­
ance rinses.

Dispensing hot water

Risk of burns
¡
The milk frother (6) gets very hot. Hold the
milk frother (6) by the plastic part only.
The appliance must be ready for use.
1. Place the pre­warmed cup or glass un­
der the outlet of the milk frother (6).
2. Set the rotary selector (6b) to the
horizontal position.
3. Press and hold the
for approx. 3 seconds. The appliance
heats up. Hot water runs out of the milk
frother outlet (6) for about 40 seconds.
4. Press the /
h
cut the process short.
TES506_1DE.indb 29
/ button (12)
h g
button (12) again to
g
Preparing milk froth and
warm milk
Risk of burns
¡
The milk frother (6) gets very hot. Hold the
milk frother (6) by the plastic part only.
Tip: You can foam the milk i rst and then
dispense coffee, or foam the milk separately
and pour it onto the coffee.
The appliance must be ready for use.
1. Place a pre­warmed cup under outlet
(6a).
2. Insert the milk tube (6c) into a milk
container.
3. Turn the rotary selector (6b) to "Milk
j
froth" or "Warm milk"
4. Press the / button (12).
h g
The / button (12) l ashes and the
h g
appliance now heats up for approx. 20
seconds.
Risk of burns
¡
Milk froth or warm milk comes out of the
milk frother (6) at high pressure. Splashes
of milk can scald. Do not touch the outlet
(6a) or aim it at anyone.
5. End the process by pressing the
button (12).
Tip: For optimal milk froth quality, use cold
milk with a fat content of at least 1.5 % if
possible.
29
i
.
/
h g
TES506.. 06/2011
16.06.2011 11:47:00