König Electronic SEC-IPCAM100B(W) Mode D'emploi page 6

Press the WPS button on your IP camera
Wait until the status LED flashes between red and green, then press and hold the
4
WPS/RESET button on your IP camera for about 2 seconds to enter WPS mode. The
status LED will be flashing green.
Enter WPS mode on the Wi-Fi router
5
Press the WPS button on the Wi-Fi router
Selecting the Wi-Fi router
6
Select the Wi-Fi router of your choice in the screen (see Figure 9).
Then select the tab:
to enter next step (see Figure 10).
IP camera connects with Wi-Fi router
7
Wait about 1-2 minutes. If the IP camera is successfully connected to the Wi-Fi router, the
status LED will become orange.
Otherwise the status LED will become a flashing red light. If the setup is not successful,
please go back to Step 1 and try again.
8
If successful, select the tab:
(see Figure 11), and follow the instructions.
Please enter a camera name and password for security and
9 select the Tab:
The IP camera will automatically enter the viewing screen (see Figure 14).
Figure9
Figure8
(see Figure 13).
6
Figure10