LENCO CR-12 Mode D'emploi page 8

FEATURES
•
Ambient light
•
Digital alarm clock with 9-minute snooze function
•
Integrated FM radio
•
Wake up with Buzzer or Radio
•
Sleep function
•
LED clock display
CLOCK and ALARM CLOCK OPERATION
Note: The time and alarm times can only be set when the radio is turned off.
TIME SET
1. The digits will flash after connecting power to the radio, or press and hold down
"MEMORY TIME SET" button (1) for approximately 3 seconds until the display flashes.
2. Press "HOUR/TUN-" button (4) repeatedly to change the hour setting.
3. Press "MIN/TUN+" button (5) repeatedly to change the minute setting.
4. Press "MEMORY TIME SET" button (1) to confirm the time.
ALARM SET
This clock radio has dual alarms that can be set and used simultaneously and the procedures
are the same. Both alarms can either sound the buzzer or wake up to radio. Follow the
instructions below to set alarm time 1. For alarm time 2, substitute "AL1/VOL-" button (2)
with "AL2/VOL+" button (3).
1. Press "AL1/VOL-" button (2) to view alarm time 1. The digits will flash.
2. Press "HOUR/TUN-" button (4) repeatedly to change the hour setting.
3. Press "MIN/TUN+" button (5) repeatedly to change the minute setting.
4. Press "AL1/VOL-" button (2) once to confirm and digits will stop flashing.
ACTIVATING THE ALARM
1. Once the alarm time is set, press "AL1/VOL-" button (2) once for alarm with buzzer
(Indicator A will be on) and twice for alarm with radio (Indicator B will be on).
2. Digits will stop flashing after a short while.
3. Press "AL1/VOL-" button (2) until all indicators off to turn off alarm.
4. When the alarm/radio sounds, press " " button (6) to turn alarm off or press "SNOOZE
SLEEP/DIMMER" button (7) for 9-minute snooze.
DISPLAY BRIGHTNESS
When the radio is off and the current time showing, press and hold "SNOOZE SLEEP/DIMMER"
button (7) to change the brightness of the display between high and low.
RADIO OPERATIONS
FM Radio Operations
8