LENCO CR-12 Mode D'emploi page 9

To
Turn radio on or off
Automatically scan
for the next station
Manually tune
Change volume
(level 0-16)
Set preset station
Change preset
stations (1-20)
Start sleep mode
AMBIENT LAMP
Press "LIGHT" button (8) to turn lamp on and off.
NOTES
Please replace all batteries at the same time with only new batteries. Remove all batteries
when the clock radio is not in use for extended periods of time.
Place the clock radio only on protected furniture. Avoid direct sunlight and any area that
may be exposed to water or moisture.
DO NOT PLUG THE RADIO INTO AN ELECTRICAL OUTLET IF YOU ARE UNSURE OF THE
VOLTAGE.
GUARANTEE
Lenco offers service and warranty in accordance with the European law, which means that in
case of repairs (both during and after the warranty period) you should contact your local
dealer.
Important note: It is not possible to send products that need repairs to Lenco directly.
Important note: If this unit is opened or accessed by a non-official service center in any way,
the warranty expires.
This device is not suitable for professional use. In case of professional use, all warranty
obligations of the manufacturer will be voided.
Do this
Press " " button (6)
Press and hold down "HOUR/TUN-" button (4) or "MIN/TUN+"
button (5)
Press "HOUR/TUN-" button (4) or "MIN/TUN+" button (5)
repeatedly
Press "AL1/VOL-" button (2) or "AL2/VOL+" button (3)
Select radio frequency. Press and hold down "MEMORY TIME
SET" button (1). Press "HOUR/TUN-" button (4) or
"MIN/TUN+" button (5) to change preset station number.
Press "MEMORY TIME SET" button (1) to confirm.
Press "MEMORY TIME SET" button (1) repeatedly.
With the radio on, press "SNOOZE SLEEP/DIMMER" button (7)
to enter sleep mode. Choose between 10 to 90 minutes.
(Indicator C will be on).
9