Fuse Replacement; Removing The Unit - Sony CDX-M8815X Mode D'emploi

When the battery becomes weak, the range of the
card remote commander becomes shorter. Replace
the battery with a new CR2025 lithium battery. Use
of any other battery may present a risk of fire or
explosion.
x
Notes on the lithium battery
• Keep the lithium battery out of the reach of children.
Should the battery be swallowed, immediately
consult a doctor.
• Wipe the battery with a dry cloth to assure a good
contact.
• Be sure to observe the correct polarity when
installing the battery.
• Do not hold the battery with metallic tweezers,
otherwise a short-circuit may occur.
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble, or dispose of
in fire.

Fuse replacement

When replacing the fuse, be
sure to use one matching the
amperage rating stated on the
original fuse. If the fuse blows,
check the power connection and
replace the fuse. If the fuse
blows again after replacement,
there may be an internal
malfunction. In such a case,
consult your nearest Sony
dealer.

Removing the unit

1
Remove the protection collar.
1 Engage the release keys together with the
+ side up
2 Pull out the release keys to remove the
2
Remove the unit.
1 Insert both release keys simultaneously
2 Pull the release keys to unseat the unit.
Fuse (10A)
3 Slide the unit out of the mounting.
protection collar.
protection collar.
until they click.
Orient the release
keys as shown.
Hook facing
inwards.
15