Maintenance And Cleaning - Oase OptiMax 560 Notice D'emploi

How to proceed:
D
• Pull off the filter housing.
• Fit the hose connector as required and
connect to a suitable hose. ( → Technical data)
• Adjust the flow at the flow regulator.
– To reduce the flow: Move the flow
regulator in the direction ‐.
– To increase the flow: Move the flow
regulator in the direction +.
• Install the device outside of the aquarium.
COMMISSIONING/START‐UP
C
• Route the power connection cable such
that it forms a drip loop!
• Switching on: Connect the unit to the
mains.
The unit switches on immediately.
• Switching off: Disconnect the unit from
the mains.

MAINTENANCE AND CLEANING

If necessary, clean the unit with clear water
using a soft brush.
• Do not use cleaning agents or chemical
solutions.
Replacing the impeller unit
E
How to proceed:
1. Loosen and remove the screws at the
side of the pump lid.
2. Remove the pump lid.
3. Remove the impeller unit.
– If necessary, use a wide-blade
screwdriver to lever the impeller unit out
of its position in the motor housing. For
this, insert the screwdriver blade into
the groove between the impeller unit
and motor housing, and firmly turn the
screwdriver in order to dislodge the
impeller from its position.
– Proceed carefully so as not to damage
the motor housing or O ring.
4. Clean or replace the impeller unit and
subsequently reassemble the pump in the
reverse order.
– OptiMax 1150/1420: Firmly push the
impeller unit into position in the motor
housing.
- EN -
11