General Precautions; Description; Installation Checks; Important - Nordica FOCOLARE 80 Idro Crystal - DSA Instructions Pour L'installation, L'utilisation Et L'entretien

Masquer les pouces Voir aussi pour FOCOLARE 80 Idro Crystal - DSA:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Focolare 80 Idro Crystal - DSA
1.

GENERAL PRECAUTIONS

La Nordica S.p.A. responsibility is limited to the supply of the appliance.
The installation must be carried out scrupulously according to the instructions provided in this manual and
the rules of the profession. Installation must only be carried out by a qualified technician who works on
behalf of companies suitable to assume the entire responsibility of the system as a whole.
La Nordica S.p.A. declines any responsibility for the product that has been modified without written
authorisation as well as for the use of non-original spare parts.
2.

DESCRIPTION

Definition: thermo-fireplace according to EN 13229
The appliance is composed of painted and galvanised sheet steel and cast iron.
The fireplace is found inside the boiler, is built in 4 mm thick steel and is reinforced using welded nails. The water in
the heating system circulates in the boiler, which absorbs the heat
produced in the fireplace.
The ceramic glass window (resistant up to 700° C) of the door
provides a lovely view of the burning flames and prevents sparks
and smoke from getting out.
Room heating takes place:
a) by radiation: the heat is radiated into the environment through
the panoramic window and the hot external surfaces of the
thermo-fireplace;
b)
by conduction: radiators or heat convectors of the centralised
system fed by hot water produced by the boiler.
The appliance is equipped with an adjustable primary air register.
1A - Primary air register (left lever)
Below the hearth door, on the front left side, there is the primary air
register, in the style of lever (Picture 1 - 1A)
With this air register, it is adjusted the passage of primary air into
the low part of the stove and through particular channels flows in
the fuel direction. The primary air is necessary for the combustion process during lighting. The ash drawer must be
regularly emptied, so that the ash does not obstruct the entry of the primary air for the combustion.
In order to open the air flow, the bar must be completely pulled out. During wood combustion, the register of primary
air must be opened only for a while, because otherwise the wood burns too fast and the stove may overheat. (see
paragraph 10).
2A - Secondary air register (right lever)
Below the hearth door, on the right front side there is the secondary air register (Picture 1 - 2A).
The secondary air, passing through the two lateral jambs of the front side, heats itself starting the double combustion
and keeping at the same time the glass clean ( with open register).
When the bar is pushed to the back the passage of the secondary is completely open (Picture 1 - 2A).
3.

INSTALLATION CHECKS

Installation of the thermo-fireplace and auxiliary equipment in relation to the heating system must comply with all
current Standards and Regulations and to those envisioned by the law.
Installation relating to the connections of the system, commissioning and the check of the correct functioning must be
carried out in compliance with the regulations in force by authorised professional personnel with the requisites
required by the law, being national, regional, provincial or town council present in the country within which the
appliance is installed, besides these present instructions.
Installation must be carried out by authorised personnel who must provide the buyer with a system declaration of
conformity certificate and will assume full responsibility for final installation and as a consequence the correct
functioning of the installed product.
NORDICA S.p.A. cannot be held responsible for lack of respect for such precautions.
Before installation, accurately wash the pipes of the system in order to remove any residuals that could compromise
the correct functioning of the appliance.

IMPORTANT:

a) In case of water leaking, close the water supply and promptly warn the after sales technical service;
b) The system working pressure must periodically be checked.
6097811 Rev.04 – EN
2A
1A
Picture 1
19

Publicité

Table des Matières
loading

Table des Matières