Cleaning The Trimmer; Battery Removal - Remington PR1250 Mode D'emploi

ENGLISH
• Pull the inner cutter carrier away from the inner cutters (Fig. D).
• Thoroughly brush hairs from the inner and outer cutters. Rinse out
remaining debris (Fig. E).
• Place the inner cutter carrier back into position and lock into place
(Fig. F-G).
• Align the spring hinge into the slot at the back of the hair pocket and press
into place. Snap the head assembly closed.
, WARNING:
Detatch the hand-held part from the supply cord before cleaning in water.
Shaver heads suitable for cleaning under an open water tap.
, CAUTION
• Do not submerge in water as damage will occur.
• Shaver heads can be rinsed with water. The water temperature should
not exceed 70 degrees. Unplug the shaver before cleaning with water.
• Keep the adaptor and cable dry.

, CLEANING THE TRIMMER

• Lubricate the teeth of the trimmer every six months with a drop of sewing
machine oil.

BATTERY REMOVAL

• The battery must be removed from the appliance before it is scrapped.
, DANGER: Once the shaver has been dismantled for disposal, do not attempt
to reassemble and/or use.
• Unplug the shaver.
• Remove the head from the shaver (Press release button and pull head
straight away from the shaver body).
• Using a small screwdriver, pry front cover from the shaver.
• Remove the 4 screws located on the front of the shaver (Fig. H).
• Remove rear cover from inner housing to expose batteries (Fig. I).
• Pry batteries free from circuit board and cut wires (Fig. J – K).
• Dispose of battery properly.
ENVIRONMENTAL PROTECTION
H
To avoid environmental and health problems due to hazardous substances
in electrical and electronic goods, appliances marked with this symbol must
not be disposed of with unsorted municipal waste, but recovered, reused or
recycled.
6