Cleaning & Maintenance; Oiling The Blades - Remington WPG-150 Guide D'utilisation Et D'entretien

Cleaning & Maintenance
To assure optimal performance,Remington ®
recommends you turn off the groomer after
each use and unplug the adapter when it's
not being used to recharge the groomer.
Clean your groomer regularly
Cleaning with brush
Your groomer's cutting blades are perma-
nently lubricated and will never need oiling
if they are never exposed to water. To main-
tain this lubrication,use the enclosed brush
to clean the unit.
Thoroughly brush and blow out hair clip-
pings from the cutter, the bottom of the
attachments,and the top of the
power handle.
Cleaning with water
Your groomer's trimmer attachments hav e
r u s t - r e s i s t a n t , stainless-steel cutting blades
t h at permit the cutting assemblies to be
rinsed under running water if you choose.
Remove all attachments
by rotating them counter-
clockwise to the unlock
position and pulling the
attachment off.
Rinse the attachments
under warm running
water. Do NOT use hot
water, which may cause damage to
components.
!
Do not use harsh or corrosive cleaners
on the unit or its attachments.
!
Do not apply pressure or hard objects
to attachments.
8
Cleaning the Mini-shaver
Thoroughly brush and blow out hair
clippings from the cutter, the bottom of
the attachments,and the top of the
power handle or you may rinse.
Press the buttons at the ends of the
screen head.
Remove the head and shake out
the clippings or rinse.
Blow off the cutter assembly or rinse.
Replace the head,making sure the unit
snaps in place.

Oiling the blades:

If you use your trimmer in the shower or
rinse the attachments,you will need to
lubricate the cutter blades once a month
with blade oil.Simply spread 1-2 drops of
oil lightly over the cutters with your finger-
tip.Wipe away any excess oil from the
cutters or the groomer.
Oil cautions
Use only the light-grade oil supplied or a
suitable alternative like sewing machine
oil – these oils will not evaporate and
will not slow down the blades.
Do not use hair oil,grease,or any oil
mixed with kerosene or solvent,as the
solvent will evaporate and leave the
thick oil,slowing the blades.
Note: Always store this appliance and cord
in a moisture-free area.Do not store it in
temperatures exceeding 140°F (60°C).
Tr o u b l e s h o o t i n g
?
If the groomer doesn't work when
turned on:
It may simply need charging.Remember,
the groomer needs to be charged for 14-16
hours before first use.If charging doesn't
solve the problem,contact an authorized
Remington Service Center regarding batter y
replacement.
?
If the groomer does not hold a charge:
Fully discharge it by running the appliance
until it stops.Then follow the recharging
instructions above.If the time between
recharging cycles does not increase, the
battery may need replacing.Contact an
authorized Remington Service Center.
?
If the cutters do not move:
The cutting unit may be dirty and clogged.
Clean and lubricate the unit as described on
the preceeding page.
Note: This appliance does not contain
any user-serviceable parts.Bring this
appliance to an authorized service
representative for service.
9